Filter
Top Products
7
Select “Time Dry” from the Home screen. The control defaults to
45 minutes.
Step 1
Step 1
Step 2
Step 2
Step 3
Step 3
Step 4
Step 4
Step 5
Step 5
time
45 min
Press START or
change your selection below.
regular
temperature
options
cycle chime loud
remind chime ON
Time
continue
45
minutes
loud end
of cycle chime
Options
continue
wrinkle prevent
on off
remind chime
on off
damp dry chime
on off
Step 6
Step 6
Press the up and down arrows to set the appro-
priate number of minutes to dry the load. The time
will increase or decrease in five minute increments.
Press “Continue”.
Select the temperature. Choose the
appropriate temperature for drying the
load.
Review Screen – The Review Screen lists the selected settings. At this point
you may press Start/Pause to begin drying the load or select “Options”
for further customization of the drying cycle.
Selecting Options. The following
options may be added to customize
your Time Dry Cycle:
• “Wrinkle Prevent”
• “Damp Dry Chime”
• “Remind Chime”
• “End of Cycle Chime”
Review Screen – The review screen will show once again to verify your
selections. If they are correct, press Start/Pause. If they are incorrect,
press the area you would like to change.
sensor dry
Home
time dry
more cycles
air fluff
(no heat)
favorite
cycles
TIME DRY
time
45 min
Press START or
change your selection below.
regular
temperature
options
cycle chime loud
remind chime ON
time
45 min
Press START or
change your selection below.
regular
temperature
options
cycle chime loud
remind chime ON
regular medium
delicate
extra low
Temperature
ONTROLS AT A GLANCE CONT.
C
time
45 min
Press START or
change your selection below.
regular
temperature
options
cycle chime loud
remind chime ON
time
45 min
Press START or
change your selection below.
regular
temperature
options
cycle chime loud
remind chime ON
Special Note: As you use the touchscreen, if
you feel you are lost, press Back or Home.