Filter
Top Products
5
CONTROLS AT A GLANCE
Step 1 Select Cycle
TIME DRY/AIR FLUFF may be
selected for any load if the AutoDry
sensor system is not used. Set the
control to the desired number of
minutes.
DAMP DRY is designed to “partially”
dry items. It provides approximately 20
minutes of heated tumbling and 5 min-
utes of cool down tumbling without heat.
WRINKLE RELEASE will release wrin-
kles from items that are clean and dry but
slightly wrinkled, such as from a crowded
closet, packed suitcase or from sitting in the
dryer too long after the end of the cycle. It
provides 10 minutes of heated tumbling and
5 minutes of cool down tumbling without
heat.
NOTE: The dial can be turned in either direction to select a cycle. Once started, the dial will not advance at a spe-
cific rate during the AutoDry cycles. At first the dial may not advance at all. Toward the end of the cycle (when the
load begins to dry) the dial will advance at a more regular rate and much more quickly. This is normal operation.
AUTODRY WRINKLE FREE FABRICS with
PRESS CARE is designed for permanent press or man-
made fabrics such as acrylic, nylon, polyester or blends. It min-
imizes wrinkling by providing an unheated cool down period at
the end of the cycle. Simply set the control to the desired dry-
ness level (more dry – less dry). The line between MORE or
LESS DRY is the initial preferred setting for the majority of
loads.
AUTODRY REGULAR is designed for loads such as
towels, underwear, t-shirts, jeans, etc. Set the control to the
desired dryness level (more dry – less dry). The line between
MORE or LESS DRY is the initial preferred setting for the
majority of loads.