Maytag MAH-1 Washer User Manual


 
5
OPERATING INSTRUCTIONS CONT.
After pressing start/pause, this display will show the estimated time remaining
in the cycle.The estimated time remaining may fluctuate to better indicate the
wash time left in the cycle.
door locked – Lights whenever the door of the clothes washer is locked.The
door can be unlocked by pressing the start/pause pad to stop the washer.
Pad Indicator Lights – The indicator lights above the pads will illuminate
when the pad is selected.
The amount of water used will vary with each load.The Maytag Neptune
®
clothes washer uses an adaptive fill valve to provide the
appropriate amount of water for efficient cleaning performance and conservation of water and energy. Fill time will vary depending
on water pressure.
WATER USE
ESTIMATED TIME DISPLAY
INDICATOR LIGHTS
Step 7
Step 6
Press the “+” or “-” signal pad to increase or decrease the end of cycle signal volume.
Close the door.
•Add detergent and additives to the dispenser (See page 6).
Push the start/pause pad.
When the washer is started after a pause,there will be a 30-second delay
before continuing the cycle.
NOTE: When the cycle is complete, the door locked light will go out.The
door will open easily. DO NOT attempt to open the washer door when the
door locked light is illuminated.To add a forgotten item, see pg. 2.
SELECT THE
S
IGNAL
START
YOUR MAYTAG N
EPTUNE
®
WASHER
Pressing off cancels the cycle and stops the washer,