Filter
Top Products
27
Note: we recommend you keep the transit bracket,
braces and screws to immobilise the machine for future
transit.
The Manufacturers will not be responsible for any
possible damage to the machine caused by not
following the rules relating to releasing the mechanism.
The user is responsible for all costs of installation.
Water connection
The appliance must be connected to the water mains using new
hose-sets. The old hose-sets should not be reused.
The machine has an inlet hose with 3/4" B.S.P threaded end
connection to attach between the threaded connector on the
appliance and the cold water supply.
The appliance must only be connected to the cold water supply.
Connection to a warm water supply, that is over 40°C, may
damage certain delicate fabrics.
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
SETTING UP + INSTALLATION
Remove the polystyrene base and place the machine near
its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of
the appliance (diagram 2).
Unscrew the central bolt (A); unscrew the 4 lateral screws
(B) and remove the cross piece (C) (diagram 3).
Lean the machine forward and remove the plastic bags
containing the two polystyrene blocks at the sides, pulling
downwards (diagram 4).
Press the plug (to be found in the envelope with the
instructions) into the hole and rotate to lock into position
(diagram 5).
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL
SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base
as shown.
Level the machine by means of the front feet.
a) Turn the nut clockwise to release the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands
firmly on the ground.
c) Lock the foot in position by turning the nut
anti-clockwise until it comes up against the bottom of the machine.
A
B
C
1
2
3
4
5
26