Before You Call (continued)..................................
Check these )oints if our washer...
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer. If
Stops equipped with buttons, be sure they are fully depressed.
• Close lid and pull knob out to start the washer. For your safety, washer will
not agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If the lid switch
should malfunction, the detector will stop fill operations for your safety. Call
for service.
*l*, °,**.._o, °*,*.* • e*.**o,* ,*.. • e*.*,* .,**.., • q ..** Q°.o.4 °, e*Q. • e*b.*,* °.0.* ° °**.., e*e.o e*l.,o, bo** °,**.m, e*.le o*.*** • °**. °***
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
Leaks Water
• Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation manual.
Is Noisy • Weak floors can cause vibration and walking.
• Be sure robber feet are installed on leveling legs.
• Turn both faucets on fully.
If equipped with a temperature selector knob, be sure it is set directly on a
temperature setting and not between settings.
Fills with • Make sure temperature selection is correct.
the Wrong , Make sure hoses are connected to correct faucets and inlet connections. Be
Temperature sure water supply is regulated correctly. Flush water line before filling
Water washer
• Check the water heater. It should be set to deliver a minimum 120°F (49°C)
hot water at the tap. Also check water heater capacity and recovery rate,
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
Forfurther help, call Maytug Customer Assistance: U.S. 1-800-688-9900 or Canada 1-800-688-2002
9