Filter
Top Products
9
cavity. (See Figure 6) Do not let the steamer operate with a dry water
tank, or the damage to the unit could occur.
3. Plug the unit into an outlet.
4. Turn on the switch. Verify that the light on the switch is illuminated. Steam
should start flowing from the nozzle in approximately 45 seconds.
5. When finishing with the steaming session place the switch to the “OFF”
position and remove the plug from the outlet.
Figure 5 Figure 6
PRESSING WITH STEAM
1. To steam a garment, place it on a clean, rust-free clothes hanger and place
the hanger on the clothes hanger hook.
2. Grasp the handle and place the steam nozzle at the bottom of the garment.
Steam will rise along the inside and outside of the fabric, removing the
wrinkles. Slowly slide the nozzle vertically from the bottom to the top of the
garment (See Figure 7). Do not allow kinks to form in the hose at any time.
3. Remove the nozzle from bottom to top on the garment and smooth the fabric
with your free hand.
4. Repeat steps 2 and 3 as necessary until the fabric is wrinkle free.
5. Curtains and draperies can be steamed while still hanging (See Figure 8).
6. Heavier fabrics may require repeated steaming.
7. To remove stubborn wrinkles, the fabric brush may also be used.
Figure 7 Figure 8