Filter
Top Products
17
Washing Programs
nt
Close the lid Finish Caution & Note
START
PAUSE
ntity of
y the
ns
t as
TER
.
ent
ctions
• The pulsator rotates for
8 seconds to detect the
laundry load.
• Then the WATER LEVEL
and the amount of
Detergent to be used
will be shown and
water will be supplied.
• Water Water level
will then be topped
up shorly. after the
wash has started to
supplement the
water the laundry
has absorbed.
• When the wash
program ends, the
chime will sound
for 10 seconds
before the Power
goes off
automatically.
• The WATER LEVEL will be set to a
higher level automatically if water is
already in the tub,or wet laundry is
loaded into the tub before starting.
• With lightweight bulky loads, a low
WATER LEVEL will be automatically
selected
• Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
3
5
6
7
6
7
6
4
4
7
6
4
• When setting the WATER LEVEL
Manually,do not set to medium or lower
in order to prevent damage to the
woollen clothes.
• Washing with HOT water may damage
the clothes. (Water is set to WARM
automatically). Ensure that the load is
under 2kg.
• In order to avoid and reduce wrinkles to
the laundry, the spin cycle may appear
slow. As a result,the clothes may contain a
higher level of moisture or water.
gent
e
oolens
ent
• When the water inlet pressure is greater
than 200kpa, The QUICK WASH course
takes approximately 19min.
•
There are several times that the
bowl will spin slowly.
This is not a malfunction. It is part
of the wash action.
7
6
4