Filter
Top Products
39
Error Determination Expected cause Remedy
SPIN Er
lamp blinks.
Unbalanced water for
spin procedure.
DOOR Er
lamp blinks and
continuous
buzz
Opened lid during
washing procedure.
(wash, rinse and spin)
Opened lid during
delay finish program.
displayed.
displayed.
Frequency generated
by recognizing water
level at pressure
switch is out of
reference value (below
15kHz)
Frequency generated
by recognizing water
level at pressure switch
is out of reference
value (below 22KHz)
1. Water is partially filled in
inner tub asm.
• Fill water evenly into inner tub
asm.(horizontally)
2. Machine is slopped (Check
drop position of leveller).
• Adjust machine height
horizontally.
3. Safety switch is too closer to
inner tub asm or safety
switch contacted wrongly.
4. Is the CONNECTOR of Ball
Pressure Sensor
disconnected or badly
touched?
• Check and replace safety
switch.
• Check B.P SENSOR
CONNECTOR or replace B.P
sensor
1. Lid is opened during all
washing procedure.
• Close lid.
2. Lid is opened during
reservation program.
• Close lid.
3. Connector of safety switch
or violet (VI) 2 pin of
controller asm is
disassembled or left wrong
contact.
• Connect connector again or
adjust wrong contact.
4. The safety switch is wrong.
(It is ON in case of the lid
closed.)
5. Ball Pressure Sensor is bad
or bad contact.
• Check and replace safety
switch.
• Check and replace Ball
Pressure Sensor.
1. The connector of Ball
Pressure Sensor (Pressure
Switch) or the blue 3 pin
connector of the controller
ASM is disassembled or
connected wrongly.
• Connect connector again and
adjust wrong contact.
2. Wrong Ball Pressure Sensor
(Pressure Switch).
1. Defect of inlet valve.
2. Defect of PWB asm.
• Replace Ball Pressure
Sensor (Pressure Switch).
• Replace the inlet valve.
• Replace the PWB asm.
3. Wrong controller asm.
• Replace controller asm.