Filter
Top Products
45
ow to use washer
H
Start/Pause
• This Start/Pause( ) button is used to
start wash cycle or pause the wash cycle.
• If temporary stop of wash cycle is needed,
press Start/Pause( ) button.
• When in pause, the power is turned off
automatically after 4 minutes.
• NB. The door will not open before 1 to 2
minutes when pause is selected,
or at the end of the wash cycle.
1. Start
2. Pause
Wash
1. Main Wash
2. Pre Wash + Main Wash
• By rotating and
Pressing the Program
Dial button, the wash
type can be selected.
- Main Wash
- Pre Wash + Main Wash
- Normal
- Super
- Rinse Hold
- No rinse
- Soak
- No Wash
• Main Wash course is available for lightly or
normally soiled laundry.
• If the laundry is heavily soiled, “Pre Wash +
Main Wash” course is effective.
• Pre Wash is available in Whites, Coloureds
and Synthetic program.
3. Soak
• Operations about 60 minutes, before “Main
Wash” course.
• “Main Wash” course is followed by “Soak
Wash” course without drain.
• “Soak Wash” is available in Whites,
Coloureds and Synthetic program.
Coloureds Time left122min
Wash Main
Pre+Main
Soak
No Wash
Rinse
Spin
Temp
Coloureds Time left122min
Wash Normal
Super
Rinse Hold
No rinse
Temp
Rinse
Spin
1. Normal
2. Super
3. Rinse Hold
Rinse
• By rotating and
pressing the Program
Dial button, the rinse
type can be selected.
• Whites / Coloureds / Synthetic performs 3 Rinses
• Wool / Hand Wash /Delicate / Quick 30
performs 2 Rinses
• Normal + 1 more rinse time.
• Use the Super rinse when additional
rinsing is desired to remove excess dirt
and detergent soiled loads.
• Is selected by rotating and pressing the
Program Dial button repeatedly this function
leaves clothes in the washer; suspended in
the water after a rinse without entering into
spin.
• To proceed through to a drain or spin, press
the Start/Pause( ) button.
• If you want to drain only, select “No spin” of
the spin course.
The required lamp will light up for identification.