Filter
Top Products
22
TROUBLESHOOTING GUIDE
• Water supply is not adequate
in area.
• Water supply taps are not
completely open.
• Water inlet hose is bent.
• The filter of the inlet hose
clogged.
• Drain hose is bent
or clogged.
• The drain filter is clogged.
• Load is too small.
• Load is out of balance.
• The appliance has an
imbalance detection and
correction system. If individual
heavy articles are loaded (bath
mat, bath robe, etc.) this
system may stop spinning or
even the spin cycle altogether
if the imbalance is too great
even after several spin starts.
• Is the door opened or not
completely closed?
• The water overfills due to the
faulty water valve.
• The water level sensor
malfunction.
• Overload in motor.
• Overload in motor.
• The washer experienced a
power failure.
• Check water supply
Check another tap in the house.
Fully open tap.
Straighten hose.
Check the filter of the inlet hose.
Clean and straighten the drain hose.
Clean the drain filter.
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning.
Close the door completely.
ƒRIf is not released, call for service.
Unplug the power plug and call for service.
Close the water tap.
Unplug the power plug.
Call for service.
Restart the cycle.
Turn the tap on.
ƒRIf is not released, unplug power
plug and call service.
Problem Possible Cause Solution