LG Electronics WD-10587BD Washer User Manual


 
16
ow to use washer
H
OPTION EST. TIME REMAINING
• Use this option for loads that need pretreatment.
Adds 16 minutes prewash and drain.
• This display shows:
a) the estimated time remaining in the cycle when
operating,
b) the error code when an error has been
detected.
STATUS INDICATOR
• These lights show which portion of the cycle the
washer is operating. (See page 15)
DOOR LOCKED
• Lights whenever the door of the washer is locked.
• The door can be unlocked by pressing the
Start/Pause ( ) button to stop the washer.
NOTA: If the water temperature or the level is too
high, the door cannot be unlocked.
Do not try to force the door open when
DOOR LOCKED lights on.
CHILD LOCK
• Use this option to prevent unwanted use of the
washer. Press and hold option button for 3
seconds to lock/unlock control.
• When Child lock is set, blinks and all buttons
are disabled except the Power ( ) button.
You can lock the washer while it is operating.
1. Prewash
• Use this option to rinse and then spin.
2. Rinse+Spin
• The Quick Cycle offers a quick cycle time.
• Suggested uses include freshening newly
purchased clothes, or clothing that has been
packed away.
3. Quick Cycle
• Adds time to the wash and rinse for better stain
removal.
• Automatically provides a rinse.
4. Stain cycle
1. Remove any clothing or items from the washer
and close the door.
2. Open the dispenser drawer and add liquid
chlorine bleach to the bleach compartment.
NOTE:
Do not add any detergent to the detergent
compartments. Excessive suds may be produced and
leak from the washer.
3. Close the dispenser drawer slowly.
4. Power on the machine, press the “option” and
then select the “Tub Clean”.
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door open
to dry around the washer door opening, door
seal and door glass.
CAUTION: If there are small children in the
house, care must be taken so that
they can not climb into or play
inside the washer while it is open
for drying.
5. Tub Clean
!