Filter
Top Products
12
REVERSING THE DOOR
Open the door and remove the two plastic
hole caps on the catch side by gently prying
up with a flat blade screwdriver. Save these
for step 6.
1
Hole cap
While supporting the door, remove the 4
screws, two from each hinge. Set the door
aside face down on a protected surface to
prevent damage to the door or the work
surface.
2
Hinge Screw
With the door on a protected surface,
remove the 12 screws on each side of the
door and lift off the inner door frame using
a flat blade screwdriver. Remove the latch
hook and blank and move them to the
opposite side.
3
inner door frame
latch hook
Remove the 4 screws securing the hinges to
the door frame. Remove the two plastic cover
caps. Reinstall the hinges and cover caps on the
opposite sides from which they were removed.
4
Hinge
assembly
Cover cap
With the hinges and cover caps in the new
locations, remount the inner door frame
onto the outer door frame with the screws
removed in step 3 above.
5
Reinstall the door with the screws from step
1,2.
6
Test the swing of the door to make sure the
hinges and latch are properly aligned and that
the door closes and latches correctly.
7
Swing Door
Support the weight of the door when removing
the screws in the next step. Failure to properly
support the weight of the door could result
in property damage, damage to the dryer, or
personal injury.
CAUTION