Filter
Top Products
BEFORE CALLING FOR SERVICE (cont.)
Problem Possible Causes Solutions
Steam doesn’t
generate but no error
code is shown.
• Water level error.
• Unplug dryer and call for service.
Garments still
wrinkled after
STEAMFRESH
™
.
• Too many or too different
types of garments in dryer.
• Small loads of 1 to 5 items work best.
• Load fewer garments. Load similar-type garments.
There are no creases
left on garment after
STEAMFRESH
™
.
• The function of this cycle
is to remove wrinkles from
fabric.
• Use an iron to make creases.
Garments have
static after REDUCE
STATIC.
• This is normal.
• Depends on individual moisture level in skin.
Garments are too
damp or too dry after
REDUCE STATIC.
• Correct drying options not
selected.
• Select load weight manually before starting
REDUCE STATIC option.
Garments are not
uniformly damp after
EASY IRON.
• This is normal.
• Depends on the amount or type of garments.
Water drips from door
during Steam Cycle.
• This is normal.
• This is steam condensation on door surface.
Steam is not visible
during Steam Cycle.
• This is normal.
• Steam vapor is difficult to see when the door is
closed.
Drum does not turn
during Steam Cycle.
• This is normal.
• The drum is turned off so that the steam vaporThe drum is turned off so that the steam vapor
remains in the drum.
Cannot see steam
vapor at the
beginning of cycle.
• This is normal.
• Steam is released at different stages of the cycleSteam is released at different stages of the cycle
for each option.
• MORE TIME button pressed.
Odors remain in
clothing after
STEAMFRESH
™
.
• STEAMFRESH
™
did not
remove odor completely.
• Fabrics containing strong odors should be
washed in a normal cycle.
The display shows
BULKY LOAD.
• Pressing the MORE TIME button several times willPressing the MORE TIME button several times will
set the cycle for a large load such as a comforter.
2 bars are displayed
In the LCD
screen.
• Ductwork is slightly too
long or has too many
turns/restrictions.
• Partial blockage of the
ductwork due to lint buildup.
• Install a shorter or straighter duct run. See theInstall a shorter or straighter duct run. See the
Installation Instructions.
• Ductwork should be checked/cleaned soon.Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times
may be longer.
• If “END OF CYCLE” is displayed after the end of
cycle, it will be off in 4 minutes. If POWER button
is pressed or the door is opened, power will be off
immediately.
4 bars are displayed
In the LCD screen.
• Ductwork is too long or has
too many turns/restrictions.
• Significant blockage of the
ductwork due to lint buildup
or debris.
• Install a shorter or straighter duct run. See theInstall a shorter or straighter duct run. See the
Installation Instructions.
• Ductwork should be checked/cleaned soon.Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times
may be longer.
• If “NEED FLOW CHECK” is displayed after the end
of cycle, it will be off in 2 hours. If POWER button
is pressed or the door is opened, power will be off
immediately.
END OF CYCLE
THE DUCTWORK HAS
A BLOCKAGE THAT NEEDS
TO BE REMOVED
IMMEDIATELY.
NEED FLOW CHECK
CHECK FILTER light
is on during the
drying cycle
• Lint filter is almost clogged
or full.
• Pause the drying cycle and clean the lint filter.
39