Filter
Top Products
7
Safety Instructions
Installation Instructions
Operating Instruction
Troubleshooting Tips
Customer Service
INSTALLING THE DRYER
● DO NOT use plastic or thin foil ducting.
● Locate dryer so exhaust duct is as short as
possible.
● Be certain old ducts are cleaned before installing
your new dryer.
● Use 4” (10.2 cm) diameter rigid or flexible metal
duct.
● The male end of each section of duct must point
away from the dryer.
● Use as few elbows as possible.
● Use duct tape on all duct joints.
● Ductwork that runs through unheated areas must
be insulated to help reduce condensation and
lint build-up on pipe walls.
● Failure to exhaust dryer properly will void
warranty.
NOTE : Venting materials are not supplied with the
dryer (obtain locally).
DO DON’T
Step 1 : Position and Level the Dryer
For further assistance refer to section on Location
Requirements.
Place the dryer in position, and adjust the legs until the
dryer is level from side to side and front to back.
Level floor : Maximum slope under entire dryer should
not be more than 2.5cm (1 inch). If slope is greater than
2.5 cm (1inch), clothes may not tumble properly and
automatic sensor cycles may not operate correctly if
dryer is not level.
Step 2 : Connect Dryer Exhaust System
For further assistance refer to sections on Location
Requirements and Dryer Exhaust Requirements.
WARNING
A clothes dryer produces combustible lint.
To reduce the risk of fire and combustion
gas accumulation the dryer MUST be
exhausted to the outdoors.