LG Electronics DLG1102W Washer/Dryer User Manual


  Open as PDF
of 80
 
22
INSTALLATION INSTRUCTIONS
Connecting electric dryers (cont.)
USA only
w
WARNING
• 





• 



Four-wire connection for electric dryers:
Power cord
• A 4-wire connection is required for all mobile and manufactured
home installations, as well as all new construction after January 1,
1996.
• A UL-listed strain relief is required.
1. Remove the terminal block access cover on the upper back of
the dryer. Install a UL-listed strain relief into the power cord
through-hole; then thread a UL-listed, 
 conductor power cord through the
strain relief.
• 
 conductor and closed loop or forked
terminals with upturned ends.
2. Transfer the dryer’s ground wire from behind the green ground
screw to the center screw of the terminal block. Attach the two
hot leads of the power cord to the outer terminal block screws.
Attach the white neutral wire to the center terminal block
screw. Attach the power cord ground wire to the green ground
screw. . Reinstall the terminal
block access cover.
UL-Listed
Strain Relief
UL-Listed
4-Wire Power
Cord
Terminal
Block
Neutral
(White)
Hot
(Black)
Hot
(Red)
Power Cord
Ground Wire
Ground
Screw
White Wire
moved from
Ground Screw
3828EL2001J_en_120727.indd 22 2012.7.27 6:16:39 PM
 previous next