Filter
Top Products
29
ENGLISH
HOW TO USE
Operating the dryer
Press the POWER button to turn on the dryer. The cycle LEDs will illuminate and a signal will
sound, if turned on. Refer to page 10.
3
A
F
CB
DGE
A
F
CB
DGE
Press the START/PAUSE button to begin the cycle. The cycle can be paused at any time either by
opening the door or by pressing the START/PAUSE button. If the cycle is not restarted within 4
minutes, the dryer will shut off and the cycle settings will be lost.
5
Press the CYCLES button until the LED for the desired cycle is on.
The preset temperature, dry level, and option settings for that cycle will be shown. Refer to page
30. Default settings for the selected cycle can now be changed if desired. This can be done using
the cycle modifier buttons as shown on page 32. Cycle options can be added using the option
buttons as shown on page 32.
Not all options or modifiers are available on all cycles. A different chime will sound and the LED
will not come on if the selection is not allowed.
4
A
F
CB
DGE
When the cycle is finished, the chime will sound if it is set. Remove your clothing from the dryer
immediately to reduce wrinkling. If
WRINKLE
CARE is selected, the dryer will tumble briefly every
few minutes to help prevent wrinkles from setting in the clothes.
6
A
F
CB
DGE
If the lint filter has not already been cleaned, lift out the filter and remove the lint from the last
load. This will help ensure the fastest and most efficient drying performance.
1
Load the dryer with the wet laundry from the washer. If the load is extra large, you may need to
divide it into smaller loads for proper performance and fabric care.
2
HOW TO USE
Lint Filter
NOTE
3828EL2001J_en_120727.indd 29 2012.7.27 6:16:56 PM