Filter
Top Products
30
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME.
(Only 1400 rpm models)
Note : Hook of connector (1) is on the backside
Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again
It may be taken off during operation.
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
(ROTOR ASSEMBLY)
(STATOR ASSEMBLY)
(FRICTION DAMPER ASSEMBLY)
Clean the drain pump filter
3
2
3
2
2.
Unplug the drain plug (),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. When
water does not flow any more, turn
the pump filter () open to the left.
3. Remove any foreign material
from the pump filter (). After
cleaning, turn the pump filter ()
clockwise and insert the drain
plug ( )to the original place.
close the lower cover cap.
1
100
1.
Open the lower cover
cap () by using a
coin. Turn the drain
plug () to pull out
the hose.