Filter
Top Products
- 9 -
The burst function can be also used
when the iron is held in vertical position
to remove creases from hanging clothes,
curtains, etc.
Using the spray-button
Provided there is sufficient water in the
tank ᕢ, you can use the spray button ¸
at any temperature setting and when
steam or dry ironing. While ironing,
press the button ¸ several times to acti-
vate the pump.
Anti-scale system
The integrated anti-scale system reduces
the build up of lime scale and increases
the user life of your iron
Using the calc clean button
It is important to use the Calc-Clean
function before putting the iron into
operation for the first time and then at
regular intervals in order to remove lime
particles and other impurities. We
recommend that the Calc-Clean function
is used at least twice a month. In areas
with very hard water, the iron should be
cleaned with the Calc-Clean function
after every use, or use distilled water.
• Fill the water up to “MAX” line in
water tank ᕢ.
• Insert the plug into the wall socket.
• Set the temperature control ᕣ to
MAX.
• Allow the iron to heat up until the
heating light Ƹ goes out and then
lights again.
• Remove the plug from the wall socket.
• Hold the iron horizontally over the sink.
• Set the steam control gear µ to calc
clean position (0) then press and hold
the calc clean button ᕤ. The boiling
water and steam will drain from the
vents in the soleplate ᕥ. Impurities
and scale will be drained away with
the water.
• Move the iron backwards and for-
wards while draining the water.
• Release the calc clean button ᕤ once
all water has been drained out.
• Place the iron in the upright position,
plug it and then allow it to heat up.
• Carefully dry soleplate ᕥ by ironing
over a towel or old cloth to ensure
there is no remainder of the water
inside the steam chamber.
• Let the iron cool down completely
before storing it.
KH2400
IB_KH2400_E6473_UK 27.06.2007 16:44 Uhr Seite 9