●
This iron complies with European
Economic Community Directive
89/336/EEC.
before using for the first time
1Remove all packaging and any
stickers or labels.
2Wind excess cord around the base
of the steam station.
3Test the iron on an old cloth to make
sure the soleplate and boiler are
clean. We recommend that you
allow steam to disperse by pressing
the steam button in order to release
any residues that may have built up
during the manufacturing process.
●
Repeat step 3 after prolonged
periods of storage.
know your Kenwood
steam station
ቢ lock for continuous steam
ባ steam button
ቤ temperature control with
indicator light
ብ soleplate
ቦ funnel
ቧ boiler cap
ቨ cord cactus locations
ቩ steam supply cord
ቪ cord storage
ቫ variable steam control
ቭ low water indicator light
ቮ on/off button
ቯ ready to steam indicator light
ተ iron rest
ቱ power supply cord
ቲ cord cactus
using your steam station
1 Place the steam station on the
support of the ironing board or any
other stable surface nearby with the
iron sitting on the iron rest. Make sure
the steam station is unplugged and
that the power and steam supply
cords are unrolled and not kinked.
2 Fit the cord cactus into one of the
cord cactus locations. Place the
steam supply cord into one of the
grooves on the other end of the cord
cactus. This will keep the cord in an
upright position.
filling with water
1 Unscrew the boiler cap by turning
anticlockwise.
2 Use the funnel to fill the boiler.
Maximum capacity when empty is
0.9 l. Take care not to overfill if the
steam station contains water.
3Refit the cap, don’t overtighten.
●
Filtered water is best as it reduces
limescale, prolonging the life of your
steam station (Kenwood water filters
are widely available). Alternatively
use 50% tap water and 50% distilled
water.
●
Do not add anything else to the
water such as water from clothes
driers, scented water, water from
refrigerators, air conditioners,
batteries, bottled mineral water or
rain water. These contain organic
waste or mineral elements that
become concentrated when heated
and cause spitting, brown staining or
premature wear to the steam station.
refilling the boiler
The red low water indicator light will
glow when the boiler requires filling.
NEVER UNSCREW THE
BOILER CAP AS LONG AS THE
BOILER IS UNDER PRESSURE.
Carry out the following procedure to
release the pressure:-
1Press the steam button until the
steam stops coming out - this may
take several minutes, then release
the steam button.
2Wait until the red low water indicator
light comes on, then press the
steam button again to release any
residual steam.
3 Switch off and unplug the steam
station and wait 5 minutes.
3
ƽ
