Kenwood IC400 Iron User Manual


 
safety
Never unscrew the boiler cap whilst
the unit is pressurised. Steam will
shoot out and burn you.
Don’t get burnt by the iron’s steam,
hot water, soleplate or iron rest.
Keep children away from the steam
station. And make sure they can’t
grab the cords and pull the steam
station down.
Trailing cords are a hazard, keep
them out of the way to prevent
accidents.
Never iron clothes being worn.
Never put the steam station, cord or
plug in liquid – you could get an
electric shock.
Always switch off and unplug the
steam station before removing the
boiler cap and filling with water.
Don’t let the power and steam
supply cords touch hot parts.
During ironing pauses and after use
always place the iron flat on the iron
rest of the steam station.
Never leave the steam station on
unattended.
Never use a damaged steam station.
Get it checked or repaired: see
‘service and customer care’.
Do not use the steam station if it has
been dropped, or if there are any
visible signs of danger or it is
leaking.
Don’t touch the appliance with wet
or damp hands.
Always unplug the steam station
when not in use and allow to cool
before moving or cleaning.
It is extremely dangerous to direct
the steam towards people or
animals.
Only use water with this appliance.
During use, the steam station must
be stable and used in a horizontal
position.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of the steam station.
Important – UK only
The wires in the cord are coloured
as follows:
Green and Yellow = Earth,
Blue = Neutral,
Brown = Live.
The appliance must be protected by
a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
2
ƽ