Kenmore 8907 Clothes Dryer User Manual


 
I I
Models : 8907*
S_dlage _ capteur
Normal
Normal
HeavyDuty
Grande Rendement
PermPress
PermPress
Delicates_
D_icats
Sanitize_
St_riJisation
f
Programme inimut_
TimedDry
S_chage_ MinLLterie
_Air Fluff
Flu× d'a#
Cy¢le_ _vapeurs
__ Refresh
RaflaTdlissement
_Touch-Up
Anti-froissement
Refresh
This cycle is best for smoothing out wrinkles and reducing odors
from loads consisting of one to four dry items. In this cycle
a small amount of water is sprayed into the dryer drum after
several minutes of tumbling with heat.
Touch Up
This cycle will release wrinkles from items that have been left
in the dryer too long. In this cycle a small amount of water is
sprayed into the dryer drum after several minutes of tumbling
with heat.
_ Overloading the dryer not yield the same results.
may
Normal
Use this cycle to dry loads such as cotton, underwear, and linen.
Heavy Duty
Use this cycle to get high heat for heavy fabrics such as jeans,
corduroys, or work clothes.
Perm Press
Dry wrinkle-free cottons, synthetic fabrics, knits, and permanent
press fabrics automatically.
Delicates
DigitalGraphicDisplay
The display window shows the estimated time remaining in the
cycle after the Start/Pause button is pressed. The estimated
time remaining may fluctuate as the cycle progresses.
If you select a course, the Indicator lights for the cycles to be
performed are turned on. (E.g. If you select Normal, the Drying
and Cooling Indicator lights are turned on.)
When the operation begins, the Indicator light of the
corresponding cycle blinks and if the cycle is complete, the
Indicator light is turned off.
If you press the 'Pause' button during an operation, the Indicator
light that was blinking turns on permanently.
When a cycle is complete, 'END' disappears if (b 5 minutes have
passed, ® the door is opened and then closed, or ® the Power
button or the Start button is pressed.
The Delicates cycle is designed to dry heat-sensitive items at a
low drying temperature.
P
Sanitize
This course allows you to sanitize garments by permeating high
temperature heat deep into the fabric during the drying cycle.
Dryness LevelSalec_on Button
To select the dry level in the Normal, HeaW Duty, or other
Sensor Dry cycles, press the Dryness Level button. An indicator
light will illuminate next to the desired dryness level.
Press the button repeatedly to scroll through the settings. Larger
or bulkier loads may require the Very Dry or More Dry setting for
Use this course to keep your bedding and curtains clean through complete dryness.
sanitization. The Less Dry setting is best suited for lightweight fabrics or for
...................................................................................................................... leaving some moisture in the clothing at the end of the cycle.
Timed Dry Use for items that lay flat or hang to dry.
Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry, then press the Adjust
Time up arrow to set the drying time.
Press the arrow repeatedly to scroll through the time settings.
Air Fluff
O
DrynessLevel
NiV_LI de s_hage
The Air Fluff cycle tumbles the load in room temperature air.
16
[BETTER]592-89075-02865 A-02 EN.indd 16
2011-03-23 L_,_ft9:49:22 I