Filter
Top Products
General Care & Cleaning (cont'd)
_O_rffice
Holder
Surface
Burner
Head
Electrode
To Clean the Recessed and Contoured Areas of the Cooktop - If a spill
occurs on or inthe recessed or contoured areas, blot up spill with an absorbent
cloth. Rinse with a clean, damp cloth and wipe dry.
To Remove and Replace the Surface Burner Caps and Surface Burner
Heads - Remove inthe following order: (1st) surface burner grate, (2nd) surface
burner cap and (3rd) surface burner heads.
Reverse the procedure above to replace the surface burner cap and surface burner
heads. Do not remove any parts from the cooktop until they have
completely cooled and are safe to handle. Do not operate the surface
burners without the surface burner cap and surface burner head properly
in place.
To Clean the Surface Burner Caps andSurface Burner Heads - Use a soap-
filled scouring pad or a mild abrasive cleanser to clean the surface burner caps
and surface burner heads. The ports (or slots) around the burner head must be
routinely cleaned. If residue still remains inthese ports, use a small-gauge wire or
needle to clean the slots or holes. For proper flow of gas and ignition of the
burner--DO NOTALLOW SPILLS, FOOD, CLEANING AGENTS ORANY
OTHER MATERIAL TO ENTER TH E GAS ORIFICE HOLDER OPENING.
ALWAYS keep the surface burner cap and surface burner head in place whenever
a surface burner is in use.
or
use
a Nail
Fig. 1
Fig. 2
about45
Oven Door
Hinge
s-
Fig. 3
Removing & Replacing the Oven Door
The door isheavy. For safe, temporary storage, lay the door flat with
the inside of the door facing down.
To Remove Oven Door:
1. Open oven door completely (horizontal with floor - See Fig. 1).
2. Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3. Insert the 2 screws into the door hinge holes located on the side of the hinge arm,
one into each hinge (See B Fig. 2).
4. Close oven door until the door stops, (Do not force the door to close any further).
The placement of these screws should keep door open in about a 45 degree
position.
5. Grasp oven door firmly on both sides and slide door up and off hinges at the same
angle. (See Fig. 3)
6. To clean oven door, followthe instructionsinthe General Care & Cleaning table.
To Replace Oven Door:
1. Besurethehingearmsremainatthe45degreeangleposifion. Besurethescrews
are still locking the hinge arms from moving. If the screws fall out of the hinge
holes, the hinge(s) may snap back against the oven frame and could pinch fingers
or chip the porcelain finish on the oven front frame.
2. Hold door at the sides near the top wile resting the lower front of door on your
knee. Insert the door channels at the bottom of door over the door hinges, (See
Fig. 3).
3. ANow the door to sNdedown into the door hinges evenly at the same 45 degree
angle. The hinge arms should be inserted into the bottom corners as far as they
can go.
4. Open door completely (horizontal with floor) and remove both screws from holes
in door hinges.
5. Reinstall the 2 screws into the door liner (See C Fig. 2).
6. If the door is not in alignment with the oven frame, remove door and repeat the
above steps.
12