Filter
Top Products
Features
Hace the front bar under
ttqe lip of the lint screen opening,
Care and Cleaning
Clean lint screen after every load.
Cycle Signal
A signal will sound at the end of the cycle and periodically during Wrinkle-Rid.
Drum Light
A drum light will come on whenever the door is opened to illuminate the dryer
drum during loading and unloading. Closing the door turns off the light.
Reversible DryerDoor
Your dryer isequipped with a reversible door. The door can be hinged on the
right or left side. Refer to the INSTALLATIONINSTRUCTIONSfor directions on
changing the door.
Drying Rack
Use the drying rack to dry items which should not be tumble dried.
I. Open the dryer door and remove the lint screen.
2. Insert drying rack into the dryer drum. Placethe front bar under the lip of
the lint screen opening.
3. Placeitems to be dried on top of the rack. Weight should not exceed 10 Ibs.
Leave space between items, but do not let items hang over the sides or
through the grids. Do not tumble other items when using the drying rack.
4. Select Time Dry. Use only the No Heat option for items containing plastic,
foam rubber, rubber-like materials, feathers or down.
5. When items are dry, remove the rack and replace the lint screen. If lint
screen is not in place, tumbling items could enter the exhaust system and
cause damage to the dryer.
To reduce risk of fire or serious injury to persons or property,
comply with the basic warnings listed in important Safety Instructions and
those listed below.
• Before cleaning the dryer interior, unplug the electricalpower cord to
avoid electrical shock hazards.
• Do not use any type spray cleanser when cleaning dryer interior. Hazardous
fumes or electrical shock could occur.
Inside
• Clean the lint screen after every load. Lint build-up in the screen restricts air
flow, which causes longer drying times. The screen is located at the bottom
of the door opening. Remove by pulling straight up. Removethe lint and
replace the screen.
CAUTION- Risk of Fire - A clothes dryer produces combustible lint. The
dryer must be connected to an exhaust outdoors. Regularly inspect the
outdoor exhaust opening and remove any accumulation of lint around the
outdoor exhaust opening and in the surrounding area.
Occasionally a waxy build-up may form on the lint screen from using dryer-
added fabric softener sheets. To remove this build-up, wash the lint screen in
warm, soapy water. Dry thoroughly and replace. Do not operate the dryer
without the lint screen in place.