Filter
Top Products
INSTALLATION INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
8" or 10" pipe wrench
8" or 10" adjustable
wrench (for gas
connections)
Flat-blade screwdriver •
Adjustable wrench that •
opens to 1" (2.54 cm) or
hex-head socket wrench
(for adjusting dryer feet)
Level •
_/4"nut driver or socket •
wrench
• Knife
• Safety glasses
• Duct tape
Pipe-joint compound
resistant to L.R gas
Caulking gun and
compound (for installing
new exhaust vent)
Gloves
Pliers
Parts supplied
Remove parts package from dryer drum. Check that all parts
were included.
1
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a
pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas
supply, electrical supply and venting. Read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing parts.
• For close-clearance installations between 31.5" (80.01 cm)
and 37" (93.98 cm), see "Plan Vent System" section for
venting requirements.
I_ 3T'
(93.99 cm
Mobile home installations require special parts (listed following)
available for purchase from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME ®(f-800-469-4663).
• Mobile Home Installation Kit. Ask for Part Number 346764.
• Metal exhaust system hardware.
Are you placing the dryer on a pedestal? You can purchase a
pedestal separately for this dryer. This pedestal will add about
14" (35.56 cm) to the height of your unit for a total height of
approximately 52" (132.08 cm).
Optionalpedestal
The pedestal is available in three colors
White - Part Number 42842
Biscuit - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call f-800-4-M¥-HOME e (1-800-469-4663).
,_0[ ....... _0 t,=*
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.
You will need
• A location that allows for proper exhaust installation. A gas
dryer must be exhausted to the outdoors. See "Venting
Requirements."
• A grounded electrical outlet located within 2 ft (61 cm) of
either side of the dryer. See "Electrical Requirements."
• A sturdy floor to support the total dryer weight of 200 Ibs
(96.7 kg). The combined weight of a companion appliance
should also be considered.
6