Kenmore 11026832692 Washer User Manual


 
Most laundering problems are easily
solved if you understand the cause.
Check these lists for common laundry
and washer problems. If you need
further assistance, see page 38.
Problem Possible Cause Solution
Washer Leaks Household plumbing is leaking. Repair plumbing.
Inlet hoses not tight. "i3ghten hoses (see "INSTALLATION:
Sections D & E).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLATION:' Section D).
Drain hose not properly Clamp drain hose
clamped or is off. (see "INSTALLATION: Section C).
Drain is clogged. Remove drain clogs. Sink, standpipe,
or floor drain must be able to handle
17 gallons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water starting washer.
to deflect off of tub ring.
Unit not level causing water Ensure front feet are installed and
to deflect off of tub ring. nuts are tightened. Level washer.
Reset rear legs (see "INSTALLATION
Section G).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off of load.
Washer is overloaded. Fills Reduce load size.
or spray rinses are deflecting
off of load.
Won't Drain/ Drain hose is kinked or Straighten or unplug hose
Won't Spin/ clogged. (see "INSTALLATION:' Section C),
Wet Loads
Correct operation of After a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than Lower drain hose
96 inches above floor. (see "INSTALLATION: Section C).
Too much detergent - Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "OPERATION").
33