Kenmore 11024904202 Washer User Manual


 
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrician determine that the
ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the
washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
1.3 prong grounding plug
2. 3 prong grounding-type outlet
3. Ground prong
4, Power supply cord
GROUNDINGINSTRUCTIONS
For a grounded, cord-connected washer:
This washer must be grounded. In the event ofa malfunction
or breakdown, grounding will reduce the risk of electrical
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is
properly installed and grounded in accordance with all local
codes and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly grounded.
Do not modify the plug provided with the appliance - if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
For a permanently connected washer:
This washer must be connected to a grounded metal,
permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal or lead on
the appliance.
INSTALLATION INSTRUCTIONS
To prevent floor damage, set the washer onto cardboard
before moving across floor.
Move the washer to within approximately 3 ft (90 cm) of the
final location.
Removing the shipping strap is necessary for smooth operation.
If the shipping strap is not removed, the washer will make
excessive noise. The washer must be in the upright position
before removinig the shipping strap.
1. Do not cut yellow strap. Pull yellow strap firmly, until
completely removed from washer. There will be two cotter
pins on the end of the shipping strap when it is pulled out of
the washer. The electrical plug is attached to this shipping
strap.
2. Pull firmly to remove the end of the shippin! strap that
remains pinned to the back of the washer. This will release
the rear self-leveling feet.
4