Filter
Top Products
8
Operating Instructions
continued
Stand the iron on its heel and turn the
Temperature Control to MIN.
Plug the power cord into a 230V or 240V
power outlet and switch on.
Select the temperature setting required
by rotating the Temperature Control dial
so that the desired setting is aligned with
the Temperature Indicator.
The Heating Indicator light will illuminate
while the iron heats to the selected
temperature.
Once the light has switched off, the iron
has reached the set temperature and
is ready for use. The light will cycle on
and off during use as the iron maintains
the temperature selected on the
Temperature Control.
CAUTION: The iron
incorporates a thermal
safety fuse to protect
the iron from over-
heating. However the
iron should not be left
unattended while it is
connected to the power
outlet. Special care
should always be taken
when there are children
in the home/ vicinity of
the iron.
Steam Ironing
When filling the iron with water, ensure
that the iron is unplugged. Set the Steam
Control to the MIN position and holding
the iron at an angle use the water cup
supplied to fill the water tank. Never
exceed the maximum water level as
indicated (MAX) on the side of the
water tank.
Tap water can be used in your
Kambrook SpeedSteam Iron unless
it is particularly hard, in which case
it is recommended that distilled or
demineralised water be used.
To Operate the
Steam Control
As per the indications on the
Temperature Control and in Table A (see
section ‘Setting the Temperature’) steam
ironing is only possible at higher ironing
temperatures, indicated with Cotton/
Linen on the Temperature Control.
Plug the power into a 230V or 240V
power outlet and switch the power on.
Set the Temperature Control to the
required position within the steam range
and wait until the Heating Indicator Light
has gone out.
Set the Steam Control (on top of the
handle) to the required setting.
Your Kambrook iron is now ready
for use.
IMPORTANT: If the iron is
set to a low temperature
on the Temperature
Control (i.e. synthetic
or silk) and also on any
of the steam control
settings, there may
be leakage from the
soleplate. This is due to
the iron temperature not
being high enough to
vaporise the water and
create steam.
Therefore, ensure
that the steam
control is always set
to correspond with
the setting on the
temperature control
as seen in Table A (see
section ‘Setting the
Temperature’).
KI400_KI460KM IB v1.indd 8 23/12/09 10:43 AM