Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
10 USK STP 23783 - 090713
Assembly page 10/24
Fax +32 2 359 95 50
TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
Steam press cannot
be opened with the
handle
Locking knob is in
locked position
Turn the locking knob
to the unlocked
position
Steam press
becomes warm but
DOES NOT remove
wrinkles.
Temperature setting is
not high enough for
the fabric attempted.
Gradually increase
the temperature until
obtaining the desired
results.
Temperature has not
been selected
Make a proper
selection.
Press is not plugged
into an outlet.
Plug the appliance
in.
Press DOES NOT get
warm.
Automatic Shut-Off
has engaged. The
pressing plate has
been raised for more
than 15 minutes
without use.
Press “ON/OFF”
again.
Water Level is too low. Fill the water tank. No Steam
Controls have not
been properly set.
If suitable for the
fabric, make a
selection to a higher
temperature. Wait for
the steam ready light
to come on. If not
use spray misting
bottle as directed.
Water drips from the
pressing plate.
Burst of steam button
has been pressed too
long.
Don t press the burst
of steam button
more than 5 seconds
continuously.
The handle will not
move into the
automatic
maximum pressure
position.
Item on the ironing
board is too thick to
use this pressure.
Use lighter pressure
on thicker items. Use
added steam for
wrinkles.