Filter
Top Products
13
8 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washer-
dryer. The light above the button will stop flashing
and remain lit.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme from the point at which it was
interrupted, press the button again.
Important!
You must set the washer-dryer to Pause before you
make any change in the programme in progress.
9 Display (Programme time)
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme (for
example 2.05).
The duration is calculated automatically on the basis
of the maximum recommended load for each type of
fabric.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
1.25
2.05
• The washer-dryer has stopped with water in the
tub, if the “Rinse hold” option has been selected or at
the end of the “Soak 30°”: this is indicated by a
flashing zero. The door locked light is still on and the
door is not openable.
• The washer-dryer has completed the
programme: this is indicated by a flashing zero.
The door locked light has gone off. It is possible now
to open the door.
After starting the programme, the remaining time is
updated every minute.
• Selection of drying time in minutes .
After starting the programme, the remaining time is
updated every minute.
Important!
If you select a drying time longer than 55’ minutes,
after 3 seconds, the display will show it in hours and
minutes (see the example below).
Example:
Time
dry
1.00
1.00
Time
dry
6060
105
0