Filter
Top Products
7
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
theycan be refitted if the machine ever has to
betransported again.
1. Using the supplied spanner unscrew and remove the
two rear bottom screws. Slide out the two plastic
pins. Lay the machine gently on its back, making sure
that the hoses are not squashed.
2. Remove the polystyrene block from the bottom of
the machine and release the two plastic bags.
3. Very carefully slide out the left polythene bag,
removing it towards the right and then downwards.
Repeat the operation for the right polythene bag,
removing it towards the left and then upwards.
4. Remove the polystyrene base.
P1127
P1126
P1124
2
3
1
P0001
P1129
5. Set the machine upright and unscrew the remaining
rear screw. Slide out the relevant pin.
6. Fill all the holes with the plastic plugs supplied with
the instruction booklet.
Important !
You are advised to keep all the packaging for re-
use in case the machine is to be transported
again.In case of moving out the same
precautions as perparagraph “The dangers of
freezing” must betaken i.e. the residual water in
the hoses must bepumped out.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Never place cardboard, wood or similar materials
under the machine to compensate for any unevenness
in the floor.
Your new washer-dryer has been designed to be
permanently plumbed in to your home’s water supply
and drainage system. However, if this is not possible, it
may be connected to a suitable existing tap with the
drain hose discharging into a sink.
The appliance has an inlet hose, with female 3/4” BSP
thread connector. If this connection is not compatible
with the plumbing of the existing installation, a variety
of connectors are available from good hardware stores
and plumbers merchants to suit most domestic
plumbing. Any alteration to your existing plumbing
must be carried out by a competent person, or
qualified plumber.
P0002
P1128