Filter
Top Products
11
6 Display
The display shows the following information:
• duration of selected programme
• delayed start
• end of programme
• incorrect option selection
• alarm code
• Duration of selected programme
After you have selected the programme, its duration (in
hours and minutes) appears on the display. It is calculated
automatically on the basis of the maximum load accepted
for each type of fabric and of the required degree of drying.
When the programme starts, the remaining time is
displayed every 5 minutes.
• Delayed start
If you have selected a delay time by means of the
relevant button, the display shows it for 2 seconds; then
it shows the duration of the previously selected programme.
The countdown is displayed every 30 minutes until it
displays “90 minutes” and then hour by hour.
• End of programme
A flashing zero indicates the end of the programme
and it is displayed after the “anti-creasing” phase.
0
3
1.20
• Incorrect option selection
If you select an option that is not compatible with the
programme you have selected, the display shows Err
(error).
This code will reappear during the execution of the
programme if you press one of the option buttons.
• Alarm code
In the case of a functional problem, the display shows
an alarm code (e.g. E21). See page 13 for more detailed
information.
7 Start/Pause button
Press this button to start the dryer after having selected
the programme and the options.
The relevant light will stop flashing. If you have chosen a
delayed start, the machine will begin the countdown.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the
programme from the point at which it was
interrupted.
In both cases the light of the Start/Pause button flashes to
remind you that the start button needs to be pressed
again.
E21
125983050.qxp 2006-01-24 15:46 Page 11