Filter
Top Products
4
4.0 Safety warnings
1. Read and understand all warnings and operating instructions before attempting to use the stacker.
2. Replace warning labels if they become obscured or removed.
3. Do not exceed rated capacity. Excessive load can cause tipping or loss of control.
4. Do not exceed load center capacity of stacker. Load center is measured horizontally from back of forks or
platform. See Figure 1. The load center (A) is 20-inches on the JHS-2200A Stacker.
5. Overall length of load must never be more than twice the load center capacity.
6. Do not allow anyone to sit or ride on fork, or enter area beneath forks.
7. Always keep fingers, hands and feet clear of forks and mast when lowering load.
8. Always secure load before raising or moving the stacker.
9. Do not allow more than half of load to extend beyond load center of stacker.
10. Always keep load close to mast.
11. Do not transport load in raised position.
12. Use on level, smooth, finished floors only. Do not use on uneven or sloping floors.
13. Pull pump release lever slowly to allow load to descend in a controlled manner.
14. Always use genuine factory replacement parts only.
15. Failure to comply with all of these warnings may result in tipping, loss of control and load, damage to
hydraulic stacker, personal injury and/or property damage.
Figure 1
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious injury or possibly even
death.