Filter
Top Products
EN
15
Troubleshooting
Possible causes / Solutions:
The plug has not been inserted far enough into the socket to make contact.
There has been a power cut.
The fuse has blown. Try connecting another appliance to the same socket.
If an extension cord is used, try connecting the dryer plug directly into the socket.
The door has not been closed properly.
The programme has not been set correctly (see How to carry out a drying cycle).
The
START/PAUSE button has not been pressed (see How to carry out a drying cycle).
A delayed start time has been set (see Programmes and options).
The
START/PAUSE button has been pressed; a short delay follows before the
dryer starts running. Wait for the drying cycle to start; do not press the START/
PAUSE
button otherwise the dryer switches to the pause mode and the drying
cycle will not start.
The filter has not been cleaned (see Care and maintenance).
The water container must be emptied? The Empty water container indicator light
flashes (see Care and maintenance).
The condenser needs to be cleaned (see Care and maintenance).
The heat setting is not suited to the type of fabric to be dried (see Programmes and
options).
An incorrect drying time was selected for the type of load (see Laundry).
The air intake grille or the rear air vents are clogged up (see Installation, and Care
and maintenance).
The items are too wet (see Laundry).
The dryer is overloaded (see Laundry).
The water container was probably not emptied before starting the programme. Do
not wait for the signal for emptying the water container, but always check and
empty it before starting a new drying programme (see Description of the tumble
dryer).
It is normal: the Empty water container indicator light flashes when the water
container is full. If the indicator light is on but is not flashing, it only signals that the
water container must be emptied (see Description of the tumble dryer).
For safety reasons, the dryer programmes last a maximum of 4 hours. If an
automatic programme has not detected the final dampness level required in this
interval, the dryer completes the programme and stops. Check the above points
and repeat the programme; if the items are still damp, contact the Technical
Assistance Centre (see Assistance).
Switch the appliance off and unplug it, then clean the filter and condenser (see Care
and Maintenance). Reinsert the plug, switch the appliance on and start another
programme.
If the problem persists, contact the Technical Assistance Service.
This is normal, especially if the dryer has not been used for a long time. If the noise
persists during the entire cycle, contact the Technical Assistance Centre.
If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical
Assistance Centre
(see Assistance).
Problem:
The dryer does not start.
The drying cycle does not start.
Drying times are too long.
The Empty water container
indicator light flashes, but the
dryer has been running for a short
time.
The Empty water container
indicator light is on but the water
container is not full.
The programme is finished but
the items are damper than
expected.
The Options and START/
PAUSE indicator lights flash and
one of the Maintenance or
Drying phases indicator lights
turns on without flashing.
The dryer is noisy during the first
few minutes of operation.