Filter
Top Products
The Controls G73UV
Timer Control
Door Release
Heat Selection
Heat selection switch
Timer Control
Turn the timer clockwise to select the required drying time.
The drying time for both heat settings is controlled by the timer. All you
have to do is turn the Timer Control clockwise slightly past the required
time and then back to the required time.
Do not rotate the knob beyond 120 (maximum drying time) or past the
zero stop. If you have selected more time than you require turn the knob
anti-clockwise to select the correct time required.
This operation also starts the dryer, provided the door is closed and the
machine is plugged in. The “Guide to Drying Times” section will tell you
how much time you’ll need for various loads.
To open door, grip handle and pull towards you.
If the door is opened while the dryer is in use, the drying programme cuts
out automatically and the machine stops. When the door is closed the
dryer will restart but you will not need to reset the timer control.
You can however reset the Timer Control at any stage should you wish.
To select high heat (Cottons and Synthetics), the Heat Selection switch
must be IN.
To select Low heat (Acrylics) the Heat Selection switch must be OUT.
See section “Guide to Drying Times”.
WARNING: CHILDREN HAVE BEEN KNOWN TO CLIMB INTO
TUMBLE DRYERS AND INJURE THEMSELVES. ALWAYS
ENSURE THAT THE MACHINE IS SWITCHED OFF AT THE
MAINS WHEN THE DRYER IS NOT BEING USED.
10