Hotpoint WMFG 821 Washer User Manual


 
14
GB
Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying
contents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not
have a wash label, or wash items that are not intended as machine washable.
The machine leaks (other than
dispenser).
The option lights and the START/PAUSE
indicator light are flash rapidly and an error
code appears on the display (eg F-01, F-..).
The machine smells.
The machine door cannot be
opened.
Door Seal damaged at the bottom.
The water level is too low when the
machine is washing.
There is too much foam.
After completing the programme,
or before starting a programme, the
machine has turned itself off (no lights).
General.
• The fill hose is loose, check both the cabinet and tap ends.
• The fill hose is tight but still leaks, if so replace the rubber washers, or the fill
hose is missing the rubber washer.
• The drain hose is not fixed in properly.
• Switch off the machine and unplug it, wait for approximately 1 minute and then
switch back on again. If the problem persists contact Technical Assistance
Centre.
• The machine requires a service wash. Run a n° 2 wash cycle with detergent
and no laundry
• The door will not open until the door lock indicator light goes out shortly after
the program has finished.
If there is no power to the machine you need to perform the manual unlocking procedure.
• The door seal has drainage holes at the bottom - This is normal.
• The water level is correct if it can be seen at the bottom of the door.
• The detergent is not suitable for machine washing (it should display the text
‘for washing machines’ or ‘hand and machine wash’ or the like).
• Too much detergent was used - less detergent is required in soft water.
• To comply with new energy saving regulations the machine is fitted with an
automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate
the machine, it can then either be switched off or a new programme selected.
• Your washing machine contains sensors that monitor progress during the wash
cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress).
Normally, if your machine successfully completes the cycle, there is unlikely to
be anything wrong!