Filter
Top Products
Getting to Know your Appliance
Plumbing Indicator Line label
Hot Water inlet point and
supplied Hose (Red or Grey end)
Cold Water inlet point and
supplied Hose (Blue end)
Transit Bolts (both MUST be removed
before using your machine).
Control Panel
Interlocking door
and release lever
Rating Plate
Mains Cable
Drainage Hose
Hooked End Support
Dispenser Drawer
Adjustable Feet
Wheels
Key Contacts
After Sales Service
Over 1200 trained specialists,directly employed by us, ensure that you can have complete confidence in both the appliances and
services we offer.
Extended Warranties
UK: 08709 088 088
(Open 8 to 8 Mon - Sun)
www.theservicecentre.co.uk
Republic of Ireland: 1850 502 200
Genuine Parts and Accessories
UK: 08709 077 077
(Open 8-30 to 5-30 Mon - Fri & 9 to 12 Sat)
www.theservicecentre.co.uk
Republic of Ireland: (01) 842 6836
Cleaning the Exterior:
Use a damp cloth or silicon polish to clean the exterior surfaces of the
appliance.
Cleaning the Door Bowl:
Clean the internal surface of the door bowl regularly with a soft cloth.
A build up of soap powder and water hardness residue may result in
water leaking from the door.
Repair Service and Information Desk
UK: 08709 066 066
(Open 8 to 8 Mon - Fri,8 to 6 Sat, 10 to 4 Sun & Bank Holidays)
www.theservicecentre.co.uk
Republic of Ireland: 1850 302 200
Note: Our operators will require the following information:
The Model number (which can be found on
the control panel)
The Serial number (which can be found on the
inner door trim)
Cleaning the Dispenser Drawer & Compartments:
It is advisable to clean the dispenser drawer regularly:
1
Pull the drawer out until it reaches its stop.
2
Press the drawer release latch
down to remove the dispenser
drawer.
4
Relocate the dispenser drawer and push it
firmly back into place.
3
A
B
Clean and dry the
dispenser drawer,
syphons, grate and
fabric conditioner exit
channel (A).
Also,regularly clean the
outlet pipe area (B).
Do not try to clean any
part of the dispenser
drawer while the machine
is working.
WARNINGS:
Do not clean any part of the
machine with abrasive cleaners,
scouring agents, acids, any
bleaches or metal polish, as
they may cause damage.