Filter
Top Products
Electricity Supply
WARNING: The appliance must be earthed.
CE marking certifies that this appliance conforms to the following
EEC directives:
Low Voltage Equipment - 72/23/EEC & 93/68/EEC
Electromagnetic Compatibility - 89/336/EEC,92/31/EEC & 93/68/EEC
Fuses
Your appliance comes fitted with a plug and a 13 amp (13A) fuse.If
you need to replace the fuse, use only those rated at 13 amp (13A)
and ASTA approved to BS1362.To change the fuse lift the holder to
vertical position and lift the fuse out.To replace the fuse, insert the
fuse and push fuse holder down into the locked position.Correct
replacement is identified by colour coding or the marking on base of
plug.
WARNING: Do not use the plug unless the fuse holder is in the locked
position and the top cover firmly replaced.
Changing the Mains Lead
If you have damaged the existing lead and need a new one,contact
Hotpoint Service UK on: 08709 066 066 or
www.theservicecentre.co.uk (or in the Republic of Ireland on: 1850
302 200). A charge will be made.We strongly advised that fitting a
new lead is carried out by a qualified electrician.
Seek professional advice if you need to use an extension lead.
Changing the Plug
If you need to change your plug, if it does not fit your socket: isolate
the machine from the mains supply.Cut off the supplied plug and
safely dispose of the discarded plug. DO NOT plug into any other
socket.
NOTE: If you change the plug,the colour of wires in the mains lead
may not match the colour of the markings which show the different
terminals in the plug.You must wire it as shown below:
Green and yellow (Earth)
wire to terminal marked ‘E’,
symbol ,or coloured
green and yellow.
Blue (Neutral) wire to
terminal marked ‘N’or
coloured black.
13A ASTA approved fuse to
BS1362.
Brown (Live) wire to terminal
marked ‘L’or coloured red.
STEP 1