Filter
Top Products
9
Variable Temperature Control Dial
●
To reduce the wash temperature of any programme except J’, turn the
dial before selecting a programme.
●
To protect laundry, you are unable to increase automatic temperature
settings.
Note: We do not recommend using the NO HEAT setting with the prewash
programmes A or B.
Button Selection
To select,press button and button comes out.To cancel, press
again and button is flush with console.
Interlocking Door System
To Open...
Grip the door handle and press the button whilst pulling open
the door (Fig 2).
To Close...
Apply pressure at the 3 o’clock position (Fig 3) until the door
clicks.
2 6
7
Start of Wash,Final Rinse
& Spin Programmes
Rinses
Short Spin
End of
Programme
Pointer
Letters represent
programme
(see page 11)
Long Spin
Fig 1
Fig 2
Fig 3
Indicator Light...
When switched on the door will lock and after a few seconds the indicator light will illuminate
throughout the programme. Approximately 1-2 minutes after the programme has finished the
indicator light will go out and the door can be opened.
WARNING: Do not attempt to open the door whilst the indicator light is on.
Wash Dial & Symbols
Before selecting a programme, ensure the mains button is in the ‘OFF’ position.Turn dial slowly
clockwise.You will hear a click as the pointer aligns with the start of your chosen wash pro-
gramme,final rinse or spin.
Note: Failure to correctly align pointer at the start of a wash programme will result in detergent
not being dispensed.
Variable Spin Speed Control Dial
To reduce the maximum programmed spin speed,turn the dial before or
during a programme.Note: Spin speed cannot be increased again whilst
the appliance is spinning.
5
4
1
3