Filter
Top Products
4. Connect to a Drainage
System...
●
Do not remove hooked end support from drainage hose.
●
Do not position standpipe near an electrical outlet.
●
For drainage into a standard work top sink ensure outlet pipe has a
minimum bore of 32 mm.To avoid syphoning ensure the end of the drainage
hose is above the water level in the sink. If your sink is inset, the front edge of
the basin must be less than 75 mm from the front edge of your work top.
We recommend one of the following
drainage methods:-
Standpipe
Note: Ensure the standpipe has a
minimum diameter of 38 mm.
1. Ensure top of standpipe is positioned
at least 500 mm from the floor (Fig 1).
2. Untie the end of the GREY drainage
hose from the rear of the appliance and
place approximately 100 mm into the
standpipe.
3. If the end of GREY drainage hose is
fitted with ‘Retaining Flaps’, ensure that
they are fully inserted into the
standpipe as shown (Fig 2).
Sink Waste System
Note: Ensure the sink outlet pipe has a
minimum diameter of 32 mm.
1. Untie the end of the GREY drainage
from the rear of the appliance.
2. Reposition ‘Hooked End Support’ as
required along GREY drainage hose.
3. If fitting an under sink waste disposal
unit (Fig 3),cut out the membrane,
bung or blanking plug (Fig 4 and 4a).
4. Attach the GREY drainage hose to the
under sink waste disposal unit securely,
using a Jubilee clip.
5. Raise the hose to a minimum height
of 800 mm to avoid syphoning.
5. Adjust the Feet...This must only be
done when the machine is upright
●
Release locking rings on the two front feet.
●
Screw feet in or out until appliance is standing
firm and level.
●
Ensure all feet are in firm contact with the floor.
●
Tighten the locking rings on the front feet.
Note: Your appliance may become noisy or move about the floor if it has not
been stabilised.
When you have installed your
appliance,ensure it is ready to use by
following this 10 Step Check List
1. Dispose of packaging safely,
see ‘Recycling Information’
on page 3.
2. Position appliance close to
electrical/water supply see
‘Location’ on page 4.
3. Remove transit bracket
and screws see ‘Transit
Bracket Removal’on page 5.
Do not remove concrete weight
4. Connect supplied hoses to
appliance water supply,confirm
water is flowing before connecting
to the appliance inlet valves
see ‘Water Supply’on page 6.
5. Untie drainage hose at rear of
appliance and connect to either
a standpipe or sink waste
drainage system see
‘Drainage’ opposite.
6. Untie mains lead at rear of
appliance and plug into electrical
supply via a switched socket,
see ‘Electrical Supply’ on
page 2.
7. Position appliance, taking care
not to kink or damage hoses
at rear of appliance.
8. Stabilise the appliance, see
‘Adjusting the feet’ opposite.
9. Turn on the water supply
to the appliance.
10. Switch on at plug socket and
carry out a routine maintenance
wash. See page 16.
500 mm
Fig 1
Fig 3
Fig 2
Fig 4 - Before
Fig 4a - After
Your appliance is now ready to use,
refer to ‘Getting to Know your
Appliance’on page 8 to familiarise
yourself with the appliance.
10 St
10 St
ep
ep
C
C
heck List
heck List
7