Filter
Top Products
9
GB
Function Effect Comments
Enabled with
programmes:
Delay
Timer
Delays the
start of the
wash by up to 9
hours.
Press the button repeatedly until the LED corresponding to
the desired delay is turned on.
The fifth time the button is pressed, the function will be
disabled.
N.B.: Once you have pressed the START button, the delay can
only be decreased if you wish to modify it.
All
Super
Wash
Allows for an
impeccable wash,
visibly whiter
than a standard
Class A wash.
1, 2, 3, 4,
5, 6, 7, 8.
Easy Iron
This option
reduces the
amount of
creasing on
fabrics, making
them easier to
iron.
When this function is set, programmes 6, 7, 8, 11 and "
Rinses
&
Slow
Spin
" will end with the laundry left to soak (Anti-crease)
and the Rinse cycle phase LED will flash.
- to conclude the cycle, press the START button;
- to run the draining cycle alone, set the knob to the relative
programme and press the START button.
All
programmes
except for
1, 2, 9, 10 and
Pump Out.
Extra
Rinse
Increases the
efficiency of
the rinse.
Recommended when the appliance has a full load or with large
quantities of detergent.
1, 2, 3, 4,
5, 6, 7, 8 and
Rinses.
Personalisations
Setting the temperature (Variable Temperature )
Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8).
The temperature can be lowered, or even set to a cold wash (Cold).
Setting the spin speed (Variable Spin speed)
Turn the VARIABLE SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cottons 1600 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting No Spin.
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner
by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed
than the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.