Hotpoint WDF 740 X Washer/Dryer User Manual


 
GB
7
Indicator lights
The indicator lights provide important information.
This is what they can tell you:
Wash cycle phase indicator lights
As the WASH CYCLE knob is rotated, the indicator lights
illuminate, indicating the stages which will be performed
by the machine in accordance with the selected wash
cycle.
Once the desired wash cycle has been selected and has
begun, the indicator lights switch on one by one to indi-
cate which phase of the cycle is currently in progress.
Note: during the “Drain” phase, the indicator light corre-
sponding to the “Spin” cycle phase will illuminate.
Function buttons and corresponding indicator lights
When a function is selected, the corresponding indicator
light will illuminate.
If the selected function is not compatible with the pro-
grammed wash cycle, the corresponding indicator light
will flash, a sound signal will be emitted and the function
will not be activated.
If a function which is incompatible with another function
selected previously, only the most recent selection will
remain active.
Temperature indicator light
When a temperature value is selected, the correspon-
ding indicator light will illuminate.
Drying indicator light
When a drying value is selected, the corresponding indi-
cator light will illuminate.
Child lock indicator light
To activate the control panel lock, press and hold the
button for approximately 2 seconds. When the indicator
light is illuminated, the control panel is locked. This
means it is possible to prevent wash cycles from being
modified accidentally, especially where there are children
in the home.
To deactivate the control panel lock, press and hold the
button for approximately 2 seconds.
Door locked indicator light
If this indicator light is on, the appliance door is locked to
prevent it from being opened accidentally; to avoid any
damage, wait for the indicator light to switch off before you
open the appliance door.
N.B. If the DELAY TIMER function is activated, the door
cannot be opened; pause the machine by pressing the
START/PAUSE button if you wish to open it.
! If the START/PAUSE indicator light (orange) flashes
rapidly at the same time as the function indicator light,
this indicates a problem has occurred (see “Troublesho-
oting”).
Starting a wash cycle
1. Switch the washing machine on by pressing the ON/OFF button. All the indicator lights will turn on for a few seconds,
then only the indicator lights relative to the selected programme settings will remain lit and the START/PAUSE indica-
tor light will flash.
2. Load the laundry and close the door.
3. Set the WASH CYCLE knob to the desired programme.
4. Set the washing temperature (see “Personalisation”).
5. Set the drying cycle if necessary (see “Personalisation”).
6. Measure out the detergent and washing additives (see “Detergents and laundry”).
7. Select the desired functions.
8. Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in
a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and
select a new cycle.
9. At the end of the wash cycle the
indicator light will switch on. The DOOR LOCKED indicator light will switch off,
indicating that the door may be opened. Take out your laundry and leave the appliance door ajar to make sure the drum
dries completely. Switch the washer-dryer off by pressing the ON/OFF button.
Wash
Rinse
Spin
Dry
End of wash cycle
Note: as soon as a drying
level or time period has been
set, this indicator light illu-
minates to indicate that the
selected wash cycle will be
followed by a drying phase.