Hotpoint WDAL 8640 Washer/Dryer User Manual


 
12
GB
Care and maintenance
Cutting off the water and electricity
supplies
• Turn off the water tap after every wash cycle. This will limit
wear on the hydraulic system inside the washer-dryer and
help to prevent leaks.
• Unplug the washer-dryer when cleaning it and during all
maintenance work.
Cleaning the washer-dryer
• The outer parts and rubber components of the applian-
ce can be cleaned using a soft cloth soaked in lukewarm
soapy water. Do not use solvents or abrasives.
• The washer-dryer has a “Auto Clean” programme for its
internal parts that must be run with no load in the drum.
For maximum performance you may want to use either the
detergent (i.e. a quantity 10% the quantity specified for lightly-
soiled garments) or special additives to clean the washer-
dryer. We recommend running a cleaning programme every
40 wash cycles.
To start the programme press buttons A and B simultaneou-
sly for 5 seconds (see figure).
The programme will start automatically and will last approxi-
mately 70 minutes. To stop the cycle press the START/PAU-
SE button.
Cleaning the detergent dispenser drawer
Remove the dispenser by
raising it and pulling it out
(see figure).
Wash it under running wa-
ter; this operation should be
repeated frequently.
Caring for the door and drum of your
appliance
• Always leave the porthole door ajar in order to prevent
unpleasant odours from forming.
Cleaning the pump
The washer-dryer is fitted with a self-cleaning pump which
does not require any maintenance. Sometimes, small items
(such as coins or buttons) may fall into the pre-chamber
which protects the pump, situated in its bottom part.
! Make sure the wash cycle has finished and unplug the
appliance.
To access the pre-chamber:
1. using a screwdriver,
remove the cover panel on
the lower front part of the
washer-dryer (see figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see
figure): a little water may
trickle out. This is perfectly
normal;
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are securely
in place before you push it onto the appliance.
Checking the water inlet hose
Check the inlet hose at least once a year. If there are any
cracks, it should be replaced immediately: during the wash
cycles, water pressure is very strong and a cracked hose
could easily split open.
! Never use second-hand hoses.
1
2
A
B