Hotpoint WD64 Washer/Dryer User Manual


 
THE WATER SUPPLY...
The Dispenser Drawer
STEP 3
Changing the Main
Wash Indicator:
Cleaning the Dispenser Drawer &
Compartments:
Dispensing Powder
Detergent
Dispensing Fabric
Conditioner
The main wash indicator
has been fitted to
dispense powder
detergent only.
If you wish to use liquid
detergent,reposition the
main wash indicator as
shown below:
1
Pull the drawer out until
it reaches its stop.
2
Press down on button,
to release the drawer
latch and remove the
drawer.
4
Relocate the drawer and
push back into place.
3
Lift the main wash
indicator out of slots,
rotate and reposition for
Liquid,ensuring it is
secure.
Index:
1. Drawer latch
2. Button
3. Main wash
indicator
4. Main wash
compartment
5. Prewash
compartment
6. Fabric conditioner
compartment.
1
2
3
4
5
6
To achieve optimum wash
results we recommend that
you use the detergent
manufacturers dispensing
cup,to dispense no more
than 300ml of powder.
Pour fabric conditioner into
the compartment.
We recommend that you do
not exceed the maximum
level indicated.
It is advisable to clean the dispenser
drawer regularly:
Remove the drawer,see ‘Changing
the Main Wash Indicator’,wash
the dispenser drawer and clean
out the compartment.
Dry thoroughly and relocate.
If you have no hot water
supply...
S OF THE INSTALLATION AND TO THOROUGHLY
F YOUR MACHINE:
E COTTON WASH PROGRAMME (refer to STEP 4)
THOUT ANY LAUNDRY
WITHOUT ANY DETERGENT
and
APPROXIMATELY 2hrs 30mins TO COMPLETE
ii
i
Check both hot and
cold water supplies
are running freely...
A cold fill adaptor is
available from your local
Hotpoint authorised Service
Centre or by
calling the
Genuine
Parts &
Accessories
Hotline
(see KEY
CONTACTS).
Connect fill hoses to
water supply taps:
- Red or Grey Hose
end to Hot
- Blue Hose end to
Cold
TURN ON BOTH TAPS
ES
ks