Filter
Top Products
Electricity Supply
STEP 1
WARNING: The appliance must be earthed.
CE marking certifies that this appliance conforms to the following
EEC directives:
Low Voltage Equipment - 72/23/EEC & 93/68/EEC
Electromagnetic Compatibility - 89/336/EEC, 92/31/EEC & 93/68/EEC
Fuses
Your appliance comes fitted with a plug and a 13A fuse. If you need to
replace the fuse, only those rated at 13A and ASTA approved to
BS1362 should be used.To change fuse lift holder to vertical position
and lift fuse out.To replace, insert fuse and push fuse holder down
into locked position. Correct replacement is identified by colour cod-
ing or the marking on base of plug.
WARNING: Do not use plug unless fuse holder is in locked position.
Changing the Mains Lead
A special lead can be ordered from Hotpoint Service
UK: 08709 066 066 or Republic of Ireland: 1850 302 200
If you have damaged the existing lead or require a longer one a
charge will be made. It is strongly advised that this work is carried out
by a qualified electrician.
Changing the Plug
Cut off and dispose of the supplied plug if it does not fit your socket.
WARNING:To avoid a shock hazard do not insert the discarded plug into
a socket anywhere else.
IMPORTANT:WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
Green/Yellow - Earth
Blue - Neutral
Brown - Live
If you change the plug, the colour of wires in the mains lead may not
correspond with the colour of the markings identifying terminals in
the plug.You should therefore wire it as shown:
Green and yellow (Earth)
wire to terminal marked ‘E’,
symbol , or coloured
green and yellow.
Blue (Neutral) wire to
terminal marked ‘N’or
coloured black.
13A ASTA approved fuse to
BS1362.
Brown (Live) wire to terminal
marked ‘L’or coloured red.
4
1
POLYSTYRENE BLOCK...
5
LEVEL?...
NOTE:
MOV
ALON
WHI
YOU
HOO
LEVEL
DRA
(*see
This is part of the packaging
and should have come away
with the polystyrene base -
IF IT HAS NOT...REMOVE IT!
NOTE: YOU MAY NEED A SECOND PERSON TO HELP YOU
RAISE AND LOWER THE APPLIANCE.
YOUR MACHINE WILL BE NOISY IF THE TWO
NOT ADJUSTED SO THE MACHINE STANDS F
Each foot has two parts: The Locking Disk a
ii
i
Release the locking disk on the
two front feet and screw the feet
in or out until the machine stands
firm and level.
Turn ON
on the t
each is
of the m
Locking
Disk
Foot
STEP 2