Hotpoint tvfg 65c Washer/Dryer User Manual


 
5
Dryer Description
GB
Important
Information Installation Description The Display
Start and
Programmes Laundry
Warnings and
Suggestions Troubleshooting Service
Maintenance
and Care
Control panel
PROGRAMME
knob
Display Unit &
Selection Buttons
START/PAUSE
Button & Light
CHILD LOCK
Button & Light
HEAT LEVEL
Button & Lights
ON/OFF
Button
CLEAN FILTER
Icon
Indicator
OPTION
Buttons & Lights
The ON/OFF button : If the dryer is running and
this button is pressed and held for more that 3 seconds
the dryer is turned off, it counts down 3, 2, 1, Off and
the programme is then cancelled.
Press and hold for more than 3 seconds and the dryer
reactivates.
The PROGRAMMES knob sets the programme: rotate
it until the indicator is pointing to the programme you want
to select (see Start and Programmes).
The OPTION buttons/lights select available options for
your selected programme. The lights indicate that the
option has been selected. If an option is not available
the buzzer will beep three times (see Start and
Programmes).
The START/PAUSE button/light starts a selected
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. When a programme is running, holding this
button in pauses the programme and stops the dryer.
The light is green when programme is running, flashing
amber if the programme has been paused or flashing
green if on standby waiting to start a programme (see
Start and Programmes).
Note: This light also flashes amber during the Post
Care phase of a programme.
The Display Unit gives an indication of the drying or
delay time together with icons that light to give warning
information and show the status of your programmes
progress. The three buttons below the display select
‘Automatic’ or ‘Timed Dry’ and if required a delayed
start (see Start and Programmes or The Display).
The CLEAN FILTER icon : gives a reminder
before every programme, that it is essential to clean
the filter every time the dryer is used (see Maintenance
and Care).
The CHILD LOCK button/light : Press and hold this
button after selecting your programme and any options,
the light turns on. This prevents the programme
settings from being changed. When the light is lit, the
other buttons are disabled. Hold the button to cancel
and the light will go out.
Control Panel
Drum
Model & Serial
numbers
Filter
The front The back
Air Intake Vent
Vent Tube fitted here
Caution: Hot!
Rating plate