Filter
Top Products
The Controls - TDL30
Timer control
Heat Selection
The ‘Cool Tumble’
phase
Heat Switch (OUT low heat, IN high heat) Indicator
Turn the timer clockwise to select the required drying time. The drying
time for both heat settings is controlled by the timer. All you have to do
is turn the Timer Control clockwise until the required time appears in
line with the indicator.
Never wind the timer control anti-clockwise.
This operation also starts the dryer, provided the door is closed and
the machine is plugged in. The “Guide To Drying Times” section will tell
you how much time you’ll need for various loads.
The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat.
The choice of FULL HEAT or LOW HEAT depends upon the fabric you
wish to dry (see section, ‘Sorting your Laundry’)
About 10 minutes before the programme is completed, the heating
elements will be switched off, and the programme enters the final ‘Cool
Tumble’ phase. During this phase, the fabric is cooled. You should
always allow the dryer to complete this phase.
By opening the door, the dryer will stop and you can check the dryness
of the load as often as you wish and, if you want to remove (or add)
some items before they are fully dry. (This is particularly useful for a
mixed load where you want to iron some items,but others to be fully
dried).
We recommend that the clothes are removed immediately the
programme is finished to minimise creasing.
Drying Guide Timer
NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE
DRUM. YOU MUST TERMINATE EVERY PROGRAMME WITH THE
COOL TUMBLE PHASE.
15