Filter
Top Products
To remove the Filter
Simply place your fingers into the
section provided at the top of the
filter (see diagram below) and pull
filter upwards.
You can now remove the fluff that has
collected on the mesh.
Don’t be alarmed at the amount of
fluff you may find on the filter; it’s all
part of the wearing, washing and
drying process.
To replace the filter push firmly into
position on the inside of the door.
WARNING: DO NOT OPERATE
THE DRYER WITHOUT THE
FILTER IN POSITION.
How to remove and
clean the Fluff Filter
A very important part of your Dryer is
the filter located on the inside of the
door. It is there to trap the particles of
lint and fluff which are normally blown
away when clothes are dried on the
washing line.
If the filter is allowed to become
blocked, the passage of warm air
through the drum will be severely
restricted. This means your clothes
will take much longer than normal to
dry and the cost of drying them
increased.
The Vent Hose, if fitted (see pages 5
and 6), should be kept free of any
possible accumulation of fluff, lint and
condensate (water) by frequently
shaking it out.
WARNING: DO NOT OPERATE
THE DRYER WITHOUT CLEANING
THE FILTER AFTER EACH
DRYING CYCLE. FAILURE TO
CLEAN THE FILTER MAY RESULT
IN A POTENTIAL FIRE HAZARD.
DO NOT ALLOW LINT TO
COLLECT AROUND THE DRYER.
16