Hotpoint TCYM 80C Clothes Dryer User Manual


 
Our ideas. Your home.
Our ideas. Your home.
Instruction booklet
TUMBLE DRYER
TCAM 80C
TCEM 80C
TCYM 80C
TCFM 80C
Important Information
FLUFF FILTER
You must clean the fluff filter after EVERY drying cycle.
Step 1
Open the door of your dryer.
Step 2
Pull out the filter (using the two
finger grips).
Step 3
Open the filter and clean any fluff
deposits from the filter mesh.
Step 4
Refit the filter with the curved
side towards you.
Step 5
Make sure the filter is pushed
fully home - NEVER run the dryer
without the filter in position.
Failure to clean the filter after EVERY drying cycle will affect
the drying performance of your machine.
It will take longer to dry and as a result will use more
electricity during drying.
You MUST empty the water container after EVERY drying cycle.
Failure to empty the water container will cause the machine to stop heating and the load may still be wet at the end of the
drying cycle. The ‘Empty Water’ light will tell you that the water container is full and needs emptying.
!
!
PRODUCT DATA... (EU Regulation 392/2012)
Rated capacity of Cotton laundry for the standard programme at full load 8 kg Energy efficiency class C
The weighted Annual Energy Consumption (AE
c
) 627.2 kWh.
Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the consumption of
the low-power modes. Actual energy consumption per cycle will depend on how the appliance is used
This household tumble dryer is a Non-Automatic Condenser Dryer
Energy consumption: full load E
dry
5.26 kWh, partial load E
dry1/2
2.91 kWh
Power consumption: off-mode (P
o
) 0.00 W
Duration of the ‘left-on mode’ for power management systems - N/A minutes
The ‘standard cotton programme’ suitable for drying normal wet cotton laundry that is the most efficient programme in terms of
energy consumption for cotton used at full and partial load is High Heat
Programme time (minutes) weighted (T
t
) full & partial load 115, full load (T
dry
) 150, partial load (T
dry1/2
) 88
Condensation efficiency class C
Average condensation efficiency (%): full load (C
dry
) 73, partial load (C
dry1/2
) 74, weighted (C
t
) full & partial load 74
Airborne acoustical noise emissions 69 dB(A) re 1 pW.
This data is also available on the website http://www.hotpoint.eu/hotpoint
This symbol reminds you to read this booklet.