Filter
Top Products
7
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
Press Guard Option
(on some models)
Use this option to minimize the wrinkles
in clothes. It provides approximately
15 minutes of no-heat tumbling after
the clothes are dry.
This option can only be used with the
COTTONS
and
WRINKLE FREE
cycles.
If you are using the
SIGNAL
knob and you
select the
PRESS GUARD
option, a signal will
sound at the end of the drying time and
several times during the
PRESS GUARD
cycle.
This will remind you that it is time to remove
the clothes.
If
PRESS GUARD
is not on, the dryer will stop
once the timer reaches the
PRESS GUARD
mark on the cycle dial.
Cycle Signal Option
(on some models)
This signal will sound just before the end
of the cycle to remind you to remove the
clothes. On some models the signal sound
level cannot be adjusted.
If you selected the
PRESS GUARD
option
the signal will sound at the end of the
drying time and will sound several times
during the
PRESS GUARD
cycle. This will
remind you that it is time to remove the
clothes.
NOTE:
■
Remove garments promptly at the sound
of the signal. Place clothes on hangers
so wrinkles won’t set in.
■
Use the Cycle Signal especially when
drying fabrics like polyester knits and
permanent press. These fabrics should
be removed so wrinkles won’t set in.
Drum Lamp
(on some models)
Before replacing the light bulb, be sure to
unplug the dryer power cord or disconnect
the dryer at the household distribution panel
by removing the fuse or switching off the
circuit breaker. Reach above dryer
opening
from inside the drum. Remove the
bulb and
replace with the same size bulb.
About the dryer features.
Hotpoint.com