Filter
Top Products
9
GB
Personalisations
Setting the spin cycle
If, when the appliance is switched on, the KNOB is positioned on
a programme with a spin cycle, a fixed
appears. Press
button
and the maximum spin speed allowed for the
programme set will be displayed, and the
icon flashes.
Press it again and the values lower until they reach OFF, which
indicates that the spin cycle has been excluded (press it again
to go back to the maximum value); stop on the desired speed,
after approximately 2 seconds the setting is accepted: the
symbol
remains fixed. The spin cycle setting is enabled with
all the programmes except for L and the Pump out cycle.
Setting the temperature
If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature
needs to be regulated, a fixed
appears. Press button and the maximum temperature allowed for the
programme set will be displayed and the
icon flashes. Press it again and the temperature lowers until it
reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the
desired value, after approximately 2 seconds the setting is accepted: the symbol
remains fixed.
The temperature adjustment is enabled with all wash programmes.
Setting the delay Timer
Press the button and you will see the word OFF on the display, while the relative symbol flashes.
Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the
"desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set
programme appears on the display and the symbol
remains on.
If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start
of the cycle. In this phase, the "delay" can only be modified by decreasing it.
The Delay Timer regulation is enabled with all programmes.
Child Lock (see page 7).
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
If you set a function that is incompatible with another function you selected previously, only the last one
selected will be enabled.
Option buttons
Function Effect Comments
Enabled with
programmes:
Super
Wash
Allows for an
impeccable wash,
visibly whiter
than a standard
Class A wash.
This function is incompatible with the QUICK WASH function.
A, B, C, D,
E, F, G, H
Easy Iron
This option
reduces the
amount of
creasing on
fabrics, making
them easier to
iron.
When this function is set, programmes F, G, H, L, N will end with
the laundry left to soak (Anti-crease) and the Rinse cycle
phase LED will flash.
- to conclude the cycle, press the START button;
- to run the draining cycle alone, set the knob to the relative
programme (R) and press the START button.
All
programmes
except for
A, B, J, K, R
Quick
Wash
Cuts the
duration of the
wash cycle by
30%.
This function is incompatible with the SUPER WASH function.
A, B, C, D,
E, F, G, H